Re: Cinematronics 2732 upgrade

Also check to make sure that the eproms you're using are fast
enough. There were a lot of really slow eproms from that generation...

Kurt

On Thu, Jun 03, 2004 at 04:06:56PM -0500, Tom McClintock wrote:
> I'd just reburn new EPROMs.
>
> Matt Rossiter wrote:
>
> >Actually, I think I'm wrong. It looks like these are marked as 8332A
> >roms. Are these compatible with 2532A eproms? The checksum I get on
> >both of these roms are F000 - which doesn't sound right. Does anyone
> >know how I can read these correctly so that I can make sure they are
> >good or make new copies?
> >
> >Thanks....
> >
> >Matt
> >
> >
> >
> > ----- Original Message -----
> > *From:* Matt Rossiter <mailto:rossiter@ni.net>
> > *To:* vectorlist@vectorlist.org <mailto:vectorlist@vectorlist.org>
> > *Sent:* Saturday, May 29, 2004 12:09 AM
> > *Subject:* VECTOR: Cinematronics 2732 upgrade
> >
> > I was just reading this
> > document. http://www.ionpool.net/arcade/cine/ccpu_upgrade.txt
> >
> > Will this upgrade work regardless of which type of roms (whether
> > 2716, 9316, or external rom board) are presently being used?
> > Currently I have a Rev. B board and it has two of the 9316 roms in
> > them. Or would it be easier to to re-wire this to take 2716's?
> > This is not a vectorbeam board. It has four empty sockets.
> >
> > By the way, did most tailgunner boards come with the external 2708
> > rom board?
> >
> > Matt

-- 
/**
 * Kurt Mahan   kmahan@xmission.com
 *
 * "Did I say that out loud?"
 */
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com