Re: SW monitor prob...

I have just read through the FAQ's for the WG6100 and in the flow chart it
mention's the zd902 (zener diode) could this be the prob ?
Col, if you have one of these can you send me one ?

Pinx

----- Original Message -----
From: "Christopher X. Candreva" <chris@westnet.com>
To: <vectorlist@vectorlist.org>
Sent: Friday, April 01, 2005 10:19 PM
Subject: Re: VECTOR: SW monitor prob...

> On Fri, 1 Apr 2005, Pinx wrote:
>
>> I have a HV probe,
>> its what i used to discharge the monitor, so i could re-cap it. What
>> voltage
>> should i set it to ?
>
> You would have to check the manual, I don't recall that off-hand -- and
> wouldn't trust my memory if I did. There are several archives of PDF
> manuals. Also the old-reliable Greg Woodcock FAQ:
>
> http://www.westnet.com/~chris/arcade/F_Greg_Woodcock.html
>
>
> ==========================================================
> Chris Candreva -- chris@westnet.com -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
> chris@westnet.com
>

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri Apr 1 16:27:45 2005