RE: Looking for p/n for neck board connector (Amplifone)

Oops! - Pins should read pin receptacles.

  _____

From: owner-vectorlist@vectorlist.org
[mailto:owner-vectorlist@vectorlist.org] On Behalf Of Bob Langelius
Sent: Friday, May 20, 2005 11:36 AM
To: vectorlist@vectorlist.org
Subject: RE: VECTOR: Looking for p/n for neck board connector (Amplifone)

Dave,
I was looking in my Mouser catalog. (Current catalog 622 Page 976) Why not
buy separate pins. Make a small pcb with a header and solder it all up?
 
Maybe $8 ea for 200
 
Bob

  _____

From: owner-vectorlist@vectorlist.org
[mailto:owner-vectorlist@vectorlist.org] On Behalf Of
Electronicamuse@aol.com
Sent: Friday, May 20, 2005 10:54 AM
To: vectorlist@vectorlist.org
Subject: Re: VECTOR: Looking for p/n for neck board connector (Amplifone)

In a message dated 5/20/2005 9:33:22 A.M. Eastern Standard Time,
bob@miltonmerl.com writes:

Could you get a board mount socket and solder wires to it?

This is for a commercial project, so that wouldn't be too safe.
 
Thanks
 
Dave
 
+++++Ask me about Retrocade 30-in-1 MultiPac kits for Midway Pac Man and Ms
Pac Man boards and same kit already attached to a new JAMMA PCB. Also we now
have purchased the rights to WG6100 (Tempest, etc) new deflection boards and
HVU boards. Also HVU boards for Amplifone (Star Wars). These are version 2
with no extra wiring or mods necessary. Ask about Star Wars overlays and new
cabinets for Midway cocktail, upright, mini, Dragon's Lair, Williams, Golden
Tee Fore, and Ultra-MAME++++

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri May 20 11:43:06 2005