Re: Another G05 issue

Hey Phil,
Thanks for the links. I was able to get it up and running with the info. It
helped me figure out that this board was set up to run with the jumper from
pin 2 to pins 4 and 5. Someone had tried to jumper it back the original way.
Thx,
jason
----- Original Message -----
From: "Phil Morris" <arcaderelics@irongiant.org.uk>
To: <vectorlist@vectorlist.org>
Sent: Sunday, November 06, 2005 1:18 PM
Subject: Re: VECTOR: Another G05 issue

>
> >I am testing the board in a working Asteroids and only swapping the
> >deflection board. I am pretty sure it's the deflection board.
>
> Have you looked at the Black and White Vector Monitor FAQ at
www.ionpool.net ?
>
> >Someone
> >mentioned the spotkiller led being bad and I don't think it's that since
I
> >have both X and Y deflection. The board works it just won't display
bright
> >enough. I'll see if I can find it on the Z circuit. What do you mean by
the
> >connector problem?
>
> Typo on my behalf - should have said 'a' connector problem, ie make sure
> that the contacts are clean, re-flow the solder on connections pins on the
> rear of the PCB, etc.
>
> My 19V2000 had a brightness problem caused by the relevant Z input cable
> breaking - it was a single core cable and had broken inside its'
protective
> sleeve, so could only be properly verified with a multimeter and
subsequent
> resistance continuity check.
>
>
>
>
> Phil
>
>
>
> --------------------------------------------------------------------------
-
> ** Unsubscribe, subscribe, or view the archives at
http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
chris@westnet.com
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.362 / Virus Database: 267.12.8/162 - Release Date: 11/05/2005
>
>

-- 
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.362 / Virus Database: 267.12.8/162 - Release Date: 11/05/2005
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com