-----Original Message-----
From: Al Warner <al@alsarcade.com>
To: vectorlist@vectorlist.org
Date: Sat, 10 Jun 2006 08:58:15 -0400
Subject: Re: VECTOR: Tempest Troubles...
>
> peter jones wrote:
>
> >the lv blowing in your monitor is unlikely to be caused by the game, but if it was then check the one of the outputs isnt stuck at maximum voltage swing.
> >
> >
> Hey Peter (& Everyone),
>
> It was the board that took out the monitor. How do you check the
> outputs? Do I meter some point on the board or on the connector that
> goes to the monitor? I just don't know the procedure and it would
> really help me get going again. I know this is basic stuff, but I'm
> learning.
>
> Thanks,
yes, meter the x & y outputs on the gameboard and make sure nether are stuck at + or - 12v or anything else for that matter - the signals should be constantly changing.
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sat Jun 10 11:23:35 2006
This archive was generated by hypermail 2.1.8 : Sat Jun 10 2006 - 18:50:01 EDT