WG6102 troubleshooting

I picked-up a a WG6102 for my Tempest cabaret and so far it's working,
with a few minor issues:

- The monitor cuts out from time to time, but a good, solid hit on the side
will turn the monitor back on (or off), so I am assuming cold-solder joints
(easy enough to fix).

- The bottom of the screen is slightly bowed upwards (I forget what that
is called). I recall reading something about there being two very specific
parts in the HV unit that causes that, but can't find the info now. If
anyone
knows the specific parts and the specific values they should have for a
WG6102, please speak-up. I've been reading through the various vector
FAQs and admit I would like to see more info specifically on the WG6102
vs. the WG6100 and WG6101. Some previous work has been done on
this monitor, but when I pull it for the repairs, I'd like to just
shotgun it with
a complete cap kit, new transistors, etc., etc., etc. The problem is I have
never seen a definitive, complete, correct, etc. list of parts
specifically for
the WG6102 to buy.

Someone sent me the WG6102 (Atari 3rd printing for X/Y quadrascan
monitor and it appears to be a WG6102) manual, so thank you to
whomever that was and I'm sorry for forgetting whom you are. That
manual is a good start, but I'm willing to bet there were some later
revisions (fixes) not covered in that manual. I've heard complaints about
suggestions or errors in the WG6100 FAQ, so I'm not sure what to believe
in it or not.
:(

Scott C.

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri Jun 23 21:22:29 2006