Re: Arghhhhhhhhhh!

And this doesn't sound like a bad idea to anyone??

For your families sake (if you have one) make sure your life insurance
is paid up and doing something like this isn't classified as attempted
suicide.

simon wrote:
> Hi Jess
> Yes sounds like a job to wear googles for sure, I can see the end of the
> pin but I'm not sure if I can get it hot enough to tin. Worth a try I
> guess. Thanks
>
> ----- Original Message -----
> *From:* Jess Askey <mailto:jess@askey.org>
> *To:* vectorlist@vectorlist.org <mailto:vectorlist@vectorlist.org>
> *Sent:* Monday, August 28, 2006 1:58 AM
> *Subject:* Re: VECTOR: Arghhhhhhhhhh!
>
> I did this exact same thing on a G-07 Raster monitor about 20 years
> ago. The method I used is still going strong on mine....
>
> If you can still actually get to the tip of the broken pin the
> glass, I used a fine tipped soldering iron to tin the end of the pin
> in the glass. Then, I tinned the end of the broken pin. Holding the
> pin with a pair of needlenose pliers, I held the pin in position
> while applying heat with the iron on the pin. Once I felt the solder
> melt and the pin slightly push inwards with the slight pressure from
> the pliers, I held steady and took off the heat. This worked very
> well for me and I then put some epoxy around the base of the pin to
> support it better.
>
> Now, there are some inherent dangers in this I suppose (I was only
> 17 when I did this). My pin was a bit below the glass, so I just
> sort of ground down the glass edges with my soldering iron tip in a
> drilling fashion until my tip hit the broken pin base.
>
> I was of course doing this with my head turned and eyes closed for
> safety purposes. ;-)

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Mon Aug 28 06:20:54 2006