Re[2]: Still having eprom troubles (looking for a programmernow)

-----Original Message-----
From: "Christopher X. Candreva" <chris@westnet.com>
To: vectorlist@vectorlist.org
Date: Sun, 1 Oct 2006 12:41:54 -0400 (EDT)
Subject: Re: VECTOR: Still having eprom troubles (looking for a programmernow)

>
> On Sun, 1 Oct 2006, Scott Caldwell wrote:
>
> > Cameron, If you're looking for a relatively cheap and good little
> > programmer, consider the Pocket Programmer II. It will program most
> > everything you could want from
>
> For the hobbiest on a real budget, another option is the Willem programmer.
> Plans available free, board and parts kits available for about $53 (actually
> 43 euors, as they are made in Europe). Parrallel only, software needs Win
> 98/me. But the hobbiest on a budget can always scrounge up an old PC. :-)
>
> http://www.willem.org/ I have an older board I bought used that needed an
> adaptor daughter board for 27xxx but I believe the current rev doesn't need
> those. Just check the supported chip list and make sure it supports what you
> need.
>
> For the hobbiest on a budget, $53 beats $250. :-)
there are chinese copies on ebay fully built for less than that, and some of them are improved too. :)

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sun Oct 1 16:54:27 2006