> What I did back in the day was to just unscrew the backplane PCB from
> the bottom of the cage and put the whole thing (backplane + cards -
> metal cage assembly) on the bench. The backplane slots are all in just
> passive/parallel, so you can mix and match boards in any order-- so put
> the ones you want to probe on the outer edge. The boards will wobble a
> little, but you can put some styrofoam or cardboard in between then to
> prevent any shorts. Not recommended for long term use, but it was fine
> for debugging...
Now that's a great idea! Thanks for the insight as usual Clay... should
make this task a little easier.
-Lewis
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Tue Jul 7 23:21:04 2009
This archive was generated by hypermail 2.1.8 : Wed Jul 08 2009 - 14:50:00 EDT