Re: wg6100 HV problem

I picked it up from another local collector, not sure where he got them.
They were NIB.

Kevin

On Mon, Oct 26, 2009 at 9:21 PM, Mark Shostak <shostakmark@gmail.com> wrote:

> Where did you get the flyback?
>
>
>
> On Mon, Oct 26, 2009 at 10:07 PM, Kevin Moore <talon.k@gmail.com> wrote:
>
>> Well orignally, it had a blown flyback, and most of the caps were shot.
>> Replaced the flyback, caps, put a zanen kit in basically. It came right up
>> after all that. Ran for about 48 hours, then blew c902, and took out r901.
>> Replaced the cap, and resistor, now it eats r901 in 10-15 mins. Looks like
>> the new flyback I installed might have gone bad.
>>
>> Kevin
>>
>>
>>
>> On Mon, Oct 26, 2009 at 8:47 PM, Mark Shostak <shostakmark@gmail.com>wrote:
>>
>>> Is it / was it producing any high voltage?
>>>
>>> What was the original symptom when you started?
>>>
>>> What has been done, other than replacing R901, R907, Q900 & Q906?
>>>
>>> Did you install or recently install a cap kit?
>>>
>>> What are the voltages from each pin of Q900 to ground?
>>>
>>> Thanks,
>>> -Mark
>>>
>>>
>>> On Mon, Oct 26, 2009 at 8:04 PM, Kevin Moore <talon.k@gmail.com> wrote:
>>>
>>>> Hello all,
>>>>
>>>> Trying to figure out a problem with a HV board. I'm pulling about 16v
>>>> across R901. R901, and R907 have been replaced with 3.9ohm 5watts. But for
>>>> the life of me I haven't been able to figure out why it's pulling that much
>>>> voltage. My others are only pulling about 2-3v. Naturally it burns up the
>>>> resistor in short order.
>>>>
>>>> q900, and 906 don't appear to be shorted, and I have swapped them for
>>>> good measure. I've been taking measurements, and checking everything, and
>>>> all seems good. I've been staring at these schematics now for hours trying
>>>> to figure out where the problem might be, and I'm at a loss right now. Brain
>>>> has officially locked up for the evening.
>>>>
>>>> Hoping one of you guys can point me in the right direction.
>>>>
>>>> Thanks,
>>>>
>>>> Kevin
>>>>
>>>>
>>>
>>
>

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Tue Oct 27 00:28:51 2009