Re: G05 HV-adjust pot replacement

As a follow-up, I went ahead and replaced the original 4.7k HV adjust
pot in a G05-805 with a new 5k pot. Works fine, and I was able to
adjust the HV to 12kv without any problems.

The new pot was a Bourns 3309P-1-502.

Alan

Mark Shostak wrote:
> You didn't specify 801 or 802, but you should be fine in either case.
> Just make sure you can adjust the anode voltage within its proper range,
> and make sure it's not on the edge.
>
> If not, on the 801 you can change R913. On the 802 you might have to get
> a little more creative. Most likely it will just work. Let us know what
> you find.
>
> -Mark
>
>
> On Thu, Jun 3, 2010 at 6:08 AM, Total Impulse <totalimpulse@comcast.net
> <mailto:totalimpulse@comcast.net>> wrote:
>
>
> I'd like to replace the HV adjustment pot in a couple G05's.
> However, I'm having trouble coming up with a direct replacement for
> the original 4.7k pot. Would it be safe to substitute a 5k pot
> instead? (That's what the V2000 used.)
>
> Thanks,
>
> Alan
> --
> Total Impulse - Just Having Fun!
> Alan Estenson, totalimpulse@comcast.net
> <mailto:totalimpulse@comcast.net>
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
> chris@westnet.com <mailto:chris@westnet.com>
>
>

-- 
Total Impulse - Just Having Fun!
Alan Estenson, totalimpulse@comcast.net
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com