Re: Tech : Electrohome G08-003 image too big

Where are you measuring this 125/100V voltage?

  The deflection board generates the +125. That is fed to the small regulator board on the side of the HV cage that beats it down to +100V.

  The 100V output is kind of hard to get to and measure- be careful not to short anything out.

  But my thought is that if you've got 100V, you're good. (Unless you're measuring 100V down on the deflection board where it should be 125.
  There are only a few components in the 125V supply including a cap C401 that could stand being a higher voltage rating.

  The 100V output directly feeds the HV transformer.

  Kerry

---- Zitt Zitterkopf <zittware@hotmail.com> wrote:
> Mark,
> Thanks.
> Assuming it does adjust - what is the impact of increasing the +126V?
> What should I set it to?
> John
>
> -----Original Message-----
> From: Mark Jenison
> Sent: Sunday, April 10, 2011 8:09 PM
> To: vectorlist@vectorlist.org
> Subject: Re: VECTOR: Tech : Electrohome G08-003 image too big
>
> The +126V is controlled by that little satilite board on the HV cage; try
> adjusting it and see what range you get.
>
> ----- Original Message -----
> From: "Zitt Zitterkopf" <zittware@hotmail.com>
> To: <vectorlist@vectorlist.org>
> Sent: Thursday, April 07, 2011 11:31 PM
> Subject: Re: VECTOR: Tech : Electrohome G08-003 image too big
>
>
> >I recapped my Monitor today; of the caps replaced C401 and C402 were
> >replaced.
> > However, my +126V is still low at about 100V or at least it's barely in
> > ranges you guys speced.
> >
> > Should I be concerned with the lowish 126V even tho the screen looks good?
> >

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Tue Apr 12 09:32:45 2011