Check in the cinelabs 6100 flyback replacement manual. IIRC there is a
picture very close to that area of the board. Your resistor may have
made it into one of the shots.
-Mark
Sent from by a human from a phone.
On May 14, 2011, at 10:05 AM, "Andrew Welburn" <andy@andysarcade.net>
wrote:
> hi all..
>
> The monitor repairs continue, and i have a couple of WG6100 HV boxes
> that someone thoguht it was clever to desolder every single
> component from, and then give up populating as its just such a big
> job, so its been left to me to finish them off.
>
> So, i've discovered a resistor that is not noted on the schematics,
> or the parts list, or the pcb descriptions... can anyone help? its a
> P329 HV pcb, sub marked 85X 0155A.. the offending resistor location
> is marked R936, there is no mention of it anywhere in the 3rd
> printing of TM-183manuals..
>
> Has anyone seen this before?
>
> --
> Andrew Welburn
> http://www.andys-arcade.com
> ---
> ---
> ---------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to chris@westnet.com
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sat May 14 13:57:19 2011
This archive was generated by hypermail 2.1.8 : Sat May 14 2011 - 14:50:00 EDT