Re: WG6100 testing

I assume you mean Q102 and Q103 on connector J100, right?

I'll make sure they have a good connection and test good. We did replace them
during the rebuild, but I'll make sure we installed them correctly and the still
work.

___
Ken

On 07/22/11 16:50, akswanson@ntelos.net wrote:
> Check your regulator bottlecap transistors.. You could have a bad
> connection..
>
>> My friend and I finished rebuilding our WG6100 monitors last night. I
>> still
>> have some power supply work to do on my Space Duel, but we figured his
>> Tempest
>> was ready for a smoke test.
>>
>> We put it all together, except for the game PCB. We stood to the side,
>> and
>> applied power. The two LEDs on the LV2000 came on, the front coin slot
>> lights
>> came on, and the CRT neck was glowing. No fuses blew. All good signs!
>>
>> However, we did not see the spot killer LED come on. I would think it
>> would
>> come on if the game board was disconnected.
>>
>> So, should I look for issues in the spot killer circuit, or is it expected
>> that the LED not come on if the game PCB is disconnected?
>>
>> A friend has an Atari vector monitor generator/tester he is going to loan
>> me
>> once he finds it. :-) I hope to use that for further testing.
>>
>> ___
>> Ken
>> ---------------------------------------------------------------------------
>> ** Unsubscribe, subscribe, or view the archives at
>> http://www.vectorlist.org
>> ** Please direct other questions, comments, or problems to
>> chris@westnet.com
>>
>
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to chris@westnet.com
>
>
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri Jul 22 22:24:06 2011