Re: Ampliphone Deflection Resistors Two Questions

Thanks William,

I ended up doing exactly as you suggested and it appears that at least one of them was replaced at some point.  I also pulled out yet another board that has never been updated and it has the correct 1.2K resistor.  I think someone just made a mistake with these. 

Thank you for the confirmation on the NI resistor and the parts link.  Those things are pricy! -Malcolm

--- On Tue, 8/23/11, William Boucher <wboucher6@cogeco.ca> wrote:

From: William Boucher <wboucher6@cogeco.ca>
Subject: Re: VECTOR: Ampliphone Deflection Resistors Two Questions
To: vectorlist@vectorlist.org
Date: Tuesday, August 23, 2011, 6:35 PM

http://www.biltronix.com ----- Original Message ----- From: Malcolm Mackenzie To: Vector List Sent: Tuesday, August 23, 2011 6:35 PM Subject: VECTOR: Ampliphone Deflection Resistors Two Questions

Rebuilding some Amplifone deflection boards and I notice that all the documentation I have says R14 should be 1.2K, but both the boards I'm working on have a 12K in that spot.  I find it interesting that the corresponding resistor on the other side is the 1.6K as the manual states.  Any thoughts on what I should use there? 

Secondly, R6 and R29 are missing on the boards.   The manual specifies wire wound, but doesn't say whether they should be non inductive or not.  I though I recalled the resistors on the WG6100 that perform the same task are non inductive.  Will it matter if I use plain old ceramic wire wound?   Thanks -Malcolm
 
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Tue Aug 23 22:17:12 2011