Got it working. Bill was right and it was just that fuse. Thanks again Bill! The fuse was not "blown" though. It checked good when I pulled it out. But if I rotated it 180 degrees it would check bad. Then rotating it again it checked fine. Never had that happen before. I guess the filament inside must have just been loose. It's working great now though!
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sat Aug 27 12:35:16 2011
This archive was generated by hypermail 2.1.8 : Sat Aug 27 2011 - 13:50:01 EDT