Re: Wico XY Pattern Generator - It's alive!

This stuff makes desoldering a large FPGA a breeze compared to a
standard DIL 8:

http://www.youtube.com/watch?v=jaarYY2Lxiw

Works exactly as described. I couldn't believe when I first tried it!

(not affiliated in any way)

Mendel

On 4-3-2012 7:33, matt wrote:
> i love crystal flux 511 solder i use a weg to solder smt ic I
> SSC-X73A
> Drag Soldering Tip
> (Increased Tinned
> Area, .24~ 6.1mm)
> http://t2.gstatic.com/images?q=tbn:ANd9GcQbsGU38P3Ta67BjpaG_c_lVc-IQVnMctXcJ6bU_bXqd9KZEQv3cg
>
> a good heat and it just flow;s pin to pin
>
>
>
> ----- Original Message ----- From: <mit@sweeet.net>
> To: <vectorlist@vectorlist.org>
> Sent: Sunday, March 04, 2012 10:25 AM
> Subject: Re: VECTOR: Wico XY Pattern Generator - It's alive!
>
>
>> >
>>> It has been my experience that the general fear of SMT is all in
>>> people's
>>> heads and it's over hyped. It's really not hard at all and once you
>>> attempt it and succeed, you'll be wondering what all of the fuss was
>>> about. There's nothing magical about SMT components. They are just
>>> chips
>>> and resistors and caps like you are used to. They are just a bit
>>> smaller
>>> and they just don't have wires attached to them and they simply sit
>>> directly on the pads. It's no big deal at all.
>>>
>>
>> I agree. I'm a complete hack and I can handle most SMT soldering jobs.
>> The guys at my job do everything by hand for small runs of boards with
>> exception of BGAs. Though, I've done a few less dense BGAs in my
>> toaster
>> oven over the years.
>>
>> Mit
>> ---------------------------------------------------------------------------
>>
>> ** Unsubscribe, subscribe, or view the archives at
>> http://www.vectorlist.org
>> ** Please direct other questions, comments, or problems to
>> chris@westnet.com
>
> ---------------------------------------------------------------------------
>
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
> chris@westnet.com
>
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sun Mar 4 19:52:34 2012