Just for kicks, try plugging the signal connector straight into the deflection board.
That is, bypass the protection board and see if you still have no picture.
Be aware the picture will be MUCH bigger.
Kerry
---- Zitt Zitterkopf <zittware@hotmail.com> wrote:
> While converging my G08; I stupidly resocketted the video connector on the monitor with power applied and lost X deflection. :forehead to palm:
> After some debug; I think the X pin shorted to the chassis temporarily.
>
> Some quick debug seems to indicate the X signal is present if I disconnect the clamping board from the main board... IE X shows up at pin1 of the output of the clamping board.
> As soon as I connect the clamping board to the main board; the signal disappears indicating there is a shorting path to ground.
>
> I’m looking at the crappy schematics (hard to read due to small nature); and it appears that the X deflection enters IC600 13,14,15 and there are no diodes / transistors in the X path prior to IC600.
>
> I woulda thunk that the 2k2 resistors (R700) would have protected IC600...
>
> Any thoughts?
>
> Am I screwed and IC600 is fried? I assume no replacements for IC600 are available?
> John
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Wed Mar 14 23:12:07 2012
This archive was generated by hypermail 2.1.8 : Thu Mar 15 2012 - 02:50:01 EDT