6100 R901/R907

So I have a 6100 HV cage that's dead. Q901/2/3 were all ruined, with the packaging broken open, and R901 is open. This is a P329 rev HV board, and I have this Bob Roberts kit which was partially installed on it. It has replacements for R901/7, but they are 2.2 ohm 5w instead of 3.9ohm 3w as the P329 schematic states. R907 is fine on this cage and it's 3.9ohm.

Is it safe to use both these 2.2 ohm resistors, or should I track down a part with the correct value? Is there anything else that would need to be swapped out if I use the 2.2 ohm jobs?
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sat Feb 9 01:54:55 2013