Really? I had my main board on the bench all by itself. What it did need was the 10.3 (in fact I hooked up all voltages -5, +5, +10.3 and +12)
On Oct 10, 2013, at 12:32 AM, Rodger Boots <rlboots2@gmail.com> wrote:
> Reset not going to work without sound board.
>
>
> On Wed, Oct 9, 2013 at 11:29 PM, Joel Griffin Dodd <griffindodd@gmail.com> wrote:
> Interconnects are good. No I didn't have the sound board installed during these tests.
>
> On Oct 9, 2013 9:25 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:
> Reset comes indirectly through sound board. Do you have a sound board installed and are interconnect cables in good shape?
>
> On Oct 9, 2013 11:07 PM, "Joel Griffin Dodd" <griffindodd@gmail.com> wrote:
> All my clocks test good on my oscilloscope the only one I haven't found a test point for is 1.5mhz where is that point.? Got a solid 1.5mhz at E and Q though at the cpu
>
> On Oct 9, 2013 9:05 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:
> Start looking for where these come from and work your way back. You did check for missing/broken crystal, right?
>
> On Oct 9, 2013 11:00 PM, "Joel Griffin Dodd" <griffindodd@gmail.com> wrote:
> Yep both still low with CPU removed
>
> On Oct 9, 2013 8:55 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:
> Could be, remove the CPU and see if they are still low. That will tell you if it is the CPU or the board.
>
> On Oct 9, 2013 10:50 PM, "Joel Griffin Dodd" <griffindodd@gmail.com> wrote:
> Hey guys. Troubleshooting my non booting star wars board set.
>
> Checked all my voltages and clicks they look good.
> Firq, NMI and halt are all high
> However reset is permanently low as is Irq at the CPU.
>
> Any ideas where to go from here? Bad CPU?
>
> I'm following the star wars troubleshooting guide
>
> Joel
>
>
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Thu Oct 10 07:24:47 2013
This archive was generated by hypermail 2.1.8 : Thu Oct 10 2013 - 09:50:00 EDT