Re: Testing PCBs...

Thanks, Tom and David...

I'm gonna roll through a few used computer stores to see if I can dig up any
of these. I actually think it would be really cool to have one of those 5"
CGA monitors, so I may just get one of them, regardless...

Does anyone know of a source for those EL4583C sync-splitters?

-atw

----- Original Message -----
From: "tom mcclintock" <tomm@mgcap.com>
To: <rasterlist@synthcom.com>
Sent: Saturday, August 18, 2001 11:33 AM
Subject: Re: RASTER: Testing PCBs...

> Drew,
>
> Here's that list of monitors for you (and anyone else). I'll give you my
> standard disclaimer that the following information was supplied in good
> faith, but I have not tested all these monitors so YMMV!
>
>
> Horizontal Frequency: =15.75 Khz
> http://www.monitorworld.com
>
> Mitsubishi FA-3415 (14") 15.7-35.5 Khz
> NEC Multisync 3DS [JC-1404HMA] (14") 15.8-38 Khz
> MITSUBISHI DIAMOND SCAN 14 (AUM-1381A) (14") 15.6-36 Khz
> NANAO FLEXSCAN 8060S (14") 15-35 Khz
> NANAO FLEXSCAN 9060S (14") 15.5-38.5 Khz
> NEC Multisync II (14") 15.5-35 Khz
> COMMODORE 1950 (AOC CM314) (14") 15-35 Khz
>
>
>
> tm
>
>
> Andrew Wilson wrote:
> >
> > Hi all,
> >
> > I'm thinking of putting together a test bench to help me work on PCBs,
make
> > adaptors, etc. I'm going to wire up a JAMMA connector, and I figure I
can
> > handle all the simple stuff (power supply, various switches, speakers).
What
> > I don't have is a monitor for my test bench, and I don't really want to
pony
> > up the money to buy a new monitor just for testing.
> >
> > What do you folks typically use for monitors on their test bench? I know
> > that some (older) PC monitors are good for this purpose, but I'm not
sure
> > what to look for to know whether the monitor will work for my test bench
or
> > not. Any tips for me?
> >
> > Failing that, if anyone in the Seattle area has an old working raster
> > monitor they'd like to sell cheap, let me know.
> >
> > Thanks,
> >
> > Drew
> >
>
> --------------------------------------------------------------------------
-
> > ** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in
the
> > ** message body to rasterlist-request@synthcom.com. Please direct other
> > ** questions, comments, or problems to neil@synthcom.com.
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to rasterlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sat Aug 18 11:46:27 2001