I did some searching for Kortek schematics a while back and found a site in Australia that had a lot of information about the monitors. You may want to search the net to find this site so you could ask the guy who runs it. As it turns out, the schematics I was looking for were not available online, so Kortek actually emailed a vector drawing of it for us. So you might even ask the source if they can offer any help. Maybe they have a flow diagram you could use.
Jon
At 10:28 AM 10/17/2001 -0400, you wrote:
>I have two of these (both a 13" and a 19") that have bad monitor boards. I
>have just started looking at them and they both have blown fuses (F602).
>Has anyone worked on a lot of these monitors? Is there a specific component
>that dies most of the time? What would cause F602 to blow? It looks to me
>that it's used on the 160 volt circuit. The 160v comes out of the flyback
>so I should be looking for a shorted component on the side of the fuse away
>from the flyback, right?
>
>Thanks for any suggestions.
>
>Werner Sharp
>sharpw@bellsouth.net
>
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
>** message body to rasterlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Wed Oct 17 07:51:39 2001
This archive was generated by hypermail 2.1.8 : Tue Dec 02 2003 - 17:51:27 EST