Sanyo 14" Capacitor Values/Locations?

All,

I'm trying to re-cap a Sanyo 14" monitor for my father-in-law (who lives 4
hours away), and have some differences between what's actually installed
in the chassis now and what the manual says should be there.

Ordinarily, I would just replace with like values and voltages, but this
chassis looks like such a hack-job as it is, and with some of the values
and voltages being substantially different than the manual lists, I need
to verify it before I recap and return on the next trip. It could be
differences in versions of the chassis as well, but better to ask than
perpetuate a nasty hack-job like this.

Below is a table of listing the differences between what's in the chassis
and what's in the manual. Obviously, caps that are installed with a
higher WVDC isn't an issue (although I'd still like to know what they are
supposed to be if possible so working voltage doesn't continue to creep up
every time it's re-capped), but the bothersome ones are where capacitance
doesn't match, or voltage is lower than specified.

(I hope this comes across OK)

Location uF (man) WVDC (man) uF (act) WVDC (act)
162 4.7 25 6.8 35
166 1 50 1 160
206 4.7 25 6.8 35
211 100 16 none
406 4.7 160 10 160
408 4.7 25 4.7 50
458 1 50 none
484 330 25 220 25
610 100 25 1 160
254 none 47 25
255 none 47 25
256 none 47 25
460 none 1 50
474 none 330 25
475 none 1 160

This is working off of the Atari manual I had in-house, as well as the
schematics I dug up online (thanks, Mike!).

Any help, pointers, or information would be GREATLY appreciated!

Brad
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Wed May 5 03:32:59 2004