Re: Gorf troubleshooting with Fluke

Andreas, you're a hero! I'd never noticed that option previously - this
could have saved me a lot of hassle.

15' for a solution to my problem - must be a record.

Thank you.

Mark

==== snip ====

On 28/05/13 22:46, Andreas Kraemer wrote:
> Alternatively just disable the force line error in the Fluke setup.
> For the 9010A there is a SETUP key on the keyboard.
> Press that one and then MORE until you see Force Line and then enter NO.
>
> -Andreas
>
> -----Urspr?ngliche Nachricht----- From: Mark Templeton
> Sent: Tuesday, May 28, 2013 11:31 PM
> To: rasterlist@vectorlist.org
> Subject: RASTER: Gorf troubleshooting with Fluke
>
> Does anyone have a quick fix for stopping the watchdog reset on a Midway
> Card Rack system (Gorf in particular)? I get the usual Force Line
> problem, but whereas on a Williams board I'd cut a track, or on an Atari
> board fit the appropriate jumper, I assume that a Gorf should need a
> specific location programmed to enable/disable watchdog. Any ideas?
>
> Mark
> ---------------------------------------------------------------------------
>
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
> chris@westnet.com
> ---------------------------------------------------------------------------
>
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
> chris@westnet.com
>

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Wed May 29 15:17:25 2013