Re: ESR meter construction question

From: Kurt Mahan <kmahan_at_xmission.com>
Date: Fri Jan 21 2000 - 11:01:29 EST

I had looked at the board before construction too. Just not close enough. :)
The shorts were really fine hairs. I had the advantage of knowing which
set of traces had to be shorted out.

Kurt

> I actually carefully looked at the PCB lit from behind before installing
> anything (WOW! I actually followed the instructions! :-) and didn't
> notice any problems. I'll check it again and look for any solder shorts.
> I found it impossible to construct w/o referring to all three images
> (picture!!!, schematic, and layout with part numbers) so I worry that
> something was installed incorrectly. Thanks!
Received on Fri Jan 21 08:12:02 2000

This archive was generated by hypermail 2.1.8 : Tue Dec 02 2003 - 18:40:32 EST