Looks like the major difference is PHI 0 and 2.
The 2 are extremely close. All address and data lines are on the same
pins. I believe op codes are the same. Definitely worth looking into.
Still looking for a 9010a RS-232 module,
JB
-----Original Message-----
From: John Robertson [mailto:jrr@flippers.com]
Sent: Tuesday, September 09, 2003 5:49 PM
To: techtoolslist@www.flippers.com
Subject: Re: [techtoolslist] 6800 -> 6502 fluke pod conversion
I haven't done it, but it sure looks easy to find out. Your 6800 pod has
to
have the jumpers though, and not all of them do.
It might be nice to make it switchable...a 2532 and some extra gates and
a
toggle switch?
John :-#)#
At 11:29 PM 09/09/2003 +0100, Dave Langley wrote:
>I was wondering ...
>
>Since the schematics for the 6502 pod show it can be jumpered to go
from
>6502 to 6800, has anyone ever converted a dedicated 6800 pod to 6502?
>
>I have a unit that I can try on, just wondering if anyone has actually
>done this already to save me re-inventing the wheel?
>
>Thanks in advance for any input ....
>
>Dave Langley
>www.robotron-2084.co.uk
>
>
Received on Tue Sep 09 23:36:21 2003
This archive was generated by hypermail 2.1.8 : Tue Dec 02 2003 - 18:40:54 EST