Re: RASTER: FW: Using 8080 pod on Midway 8080 boards (Space Invaders)

David Shoemaker wrote:
> What I am trying to figure out is are both my pods bad (which I doubt as two
> are behaving the same way) or is my 9010.
>

If you are wondering if the base (9010/9100) affects the Run UUT command
the answer is no. When the pod is in the RUN UUT mode it is entirely
independent from the base - other than it can be over-ridden with a
command - it does not talk to the base at all. This is covered somewhere
in the manuals... Some of the manuals are searchable - look up RUN UUT
and see what is written, pretty sure I've remembered it correctly. All
the base does is tell the CPU where the Reset Vector is, after that the
pod is on it's own.

John :-#)#
> -----Original Message-----
> From: prvs=1763d5e072=ayeckley@sierralobo.com
> [mailto:prvs=1763d5e072=ayeckley@sierralobo.com] On Behalf Of Alex Yeckley
> Sent: Wednesday, February 20, 2013 4:15 AM
> To: 'David Shoemaker'; 'Technical Tools Mail List'; jrr@flippers.com;
> rasterlist@vectorlist.org
> Subject: RE: [Techtoolslist] RASTER: FW: Using 8080 pod on Midway 8080
> boards (Space Invaders)
>
>
>> Do your pods have the twisted cable or the straight? Both mine have
>> the straight.
>>
>
> Our 8080 pods have the OEM twisted cables. Our 6502 pods (re: Clay's
> Tempest question) come in both twisted and the flat cables. I'm assuming
> the flat cable is a non-factory replacement item, but could be totally wrong
> about that. The 6502 pod that failed just happened to have had a flat cable
> but I'm confident the drive problem was unrelated; we found one specific
> driver output that wasn't going sufficiently high once plugged into a "real"
> target board. It wasn't a general malaise of the address lines like you
> might expect from transmission line losses or higher EMI susceptibility due
> to the flat cable if that's what you are wondering.
>
>
>> Are you using a 9010 or a 9100 to drive the pod?
>>
>
> Both...
>
> Alex
> ----
> ayeckley@elektronforge.com
> www.elektronforge.com
>
>
>
>
>

-- 
John's Jukes Ltd. 2343 Main St., Vancouver, BC, Canada V5T 3C9 
Call (604)872-5757 or Fax 872-2010 (Pinballs, Jukes, VideoGames)
                 www.flippers.com 
"Old pinballers never die, they just flip out"
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/