Re: Fluke 6809 Pod Troubleshooting

On 04/16/2013 8:39 AM, Theron Troxel wrote:
> I have a 6809 pod that I finally got around to testing and is coming up with "POD TIMEOUT - ATTEMPTING RESET" error. Looking at the manual for the 6809 pod, it says to check for short to the crystal or clock depending on the chip. Would I start on pin 39 of the self test socket and follow the schematics back and check the lines on U27, U22, and U23 that's if the enable line on U27 is low? Or, am I looking in the wrong spot on the schematics?
>
> Any other advice when trouble shooting these?
> _______________________________________________

Assuming you have a good 6809 CPU in the pod socket and that it is the
correct version (6809 vs 6809E) I would be checking for bent pins, etc.
The pod 6809 should show clock signals all the time, so you can check
for those with a logic probe.

John :-#)#
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ttl.arcadetech.org/TTL/Test_Equipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
Received on Tue Apr 16 12:59:56 2013