>So if I have a Battle Zone board (notice a pattern yet? :) with a problem
>at the first amp out from the DAC and I want to check the DAC output with
>my scope.
>
>I guess that I can't just go into XY mode on the scope and check the DAC
>output.
>
>So how would I check to make sure that is OK short of breadboarding a TL082
>and using that to check my outputs?
Just a stab here, but couldn't you hang a couple resistors in series off
the DAC output and tie the other end to ground? Then probe at the center
resistor and see the voltage potential there? It'd probably work with just
one too, but I'm working one something else and not actually thinking much
at the moment... YMMV.
-Clay
Clayton N. Cowgill Engineering Manager
_______________________________________________________________________
/\ Diamond Multimedia Systems, Inc. clay@supra.com
\/ Communications Division http://www.supra.com/
Received on Mon Jan 19 17:04:16 1998
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:31:06 EDT