Maybe you can fill the slot with solder and file it down smooth. You may have to file the
finish off the screw to get the solder to stick.
"Christopher X. Candreva" wrote:
>
> On Mon, 12 Jul 1999, Jon Raiford wrote:
>
> > I took some pics of both the top half of the case (the half
> > that holds these studs) and some close-up's of the studs
> > themselves (get your mind out of the gutter!). Anyway, I sent
> > them to Chris to show him, but if you guys would like to see
>
> . . . And I was about to post that I put them up:
>
> http://www.westnet.com/~chris/arcade/roller/
>
> I ended up just putting a #6 by .5" round-head bolt in there. It works, it's
> slot head is wearing the roller a bit, so I'm going to experiment and find
> something else. They didn't seem to have a stud like this.
>
> Mine had a screw in the top position too. For some reasons when I first
> looked at it, I thought the arm-bit was bolted on, but obviously, it's not.
>
> -Chris
>
> ==========================================================
> Chris Candreva -- chris@westnet.com -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
Received on Mon Jul 12 10:05:51 1999
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:31:27 EDT