Re: Major Havoc Roller Controller (Shafts)

On Mon, 12 Jul 1999, Jon Raiford wrote:

> I took some pics of both the top half of the case (the half
> that holds these studs) and some close-up's of the studs
> themselves (get your mind out of the gutter!). Anyway, I sent
> them to Chris to show him, but if you guys would like to see

 . . . And I was about to post that I put them up:

http://www.westnet.com/~chris/arcade/roller/

I ended up just putting a #6 by .5" round-head bolt in there. It works, it's
slot head is wearing the roller a bit, so I'm going to experiment and find
something else. They didn't seem to have a stud like this.

Mine had a screw in the top position too. For some reasons when I first
looked at it, I thought the arm-bit was bolted on, but obviously, it's not.

-Chris

==========================================================
Chris Candreva -- chris@westnet.com -- (914) 967-7816
WestNet Internet Services of Westchester
http://www.westnet.com/
Received on Mon Jul 12 09:31:54 1999