You could try a NYLON bolt.
"Christopher X. Candreva" wrote:
> On Mon, 12 Jul 1999, Jon Raiford wrote:
>
> > I took some pics of both the top half of the case (the half
> > that holds these studs) and some close-up's of the studs
> > themselves (get your mind out of the gutter!). Anyway, I sent
> > them to Chris to show him, but if you guys would like to see
>
> . . . And I was about to post that I put them up:
>
> http://www.westnet.com/~chris/arcade/roller/
>
> I ended up just putting a #6 by .5" round-head bolt in there. It works, it's
> slot head is wearing the roller a bit, so I'm going to experiment and find
> something else. They didn't seem to have a stud like this.
>
> Mine had a screw in the top position too. For some reasons when I first
> looked at it, I thought the arm-bit was bolted on, but obviously, it's not.
>
> -Chris
>
> ==========================================================
> Chris Candreva -- chris@westnet.com -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
Received on Mon Jul 12 14:13:09 1999
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:31:27 EDT