Of course, the upgrade isn't complete until you pull the square, boxy caps (#C603 & #C703). Pulling these caps cleaned up some shakes on one of my vectors. FWIW, you will notice that the parts are not listed in the revision 3 manual with no noticeable difference to the surrounding circuit - they just pulled them.
Jon
At 10:19 AM 3/3/2000 -0600, you wrote:
>Have a slight problem with my Black Widow that I hope somebody can help me with. The video shakes vertically a bit and is most noticeable in the high score table. In the demo mode and during gameplay its not noticeable - but when I go to enter initials in the high score table, there is a definite vertical shaking (more than the common vector flicker).
>
>The monitor (WGK6100) has just been capped with a kit from Bob Roberts + the extra upgrade parts. I have an LV2000, but its not installed yet. Just don't know if its the monitor or the vector generation portion of the game board.
>
>Thanks for the help.
>
>Walt
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Mar 3 14:02:21 2000
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:31:57 EDT