I think if you go back and look at the pictures I put up again you will see
that the contact point of the green roller to the steel roller wore down the
steel about 1/16 of an inch! I just got feedback from the set I put in Jons MH
controller and he is real happy but Ill wait for him to comment himself.
"Christopher X. Candreva" wrote:
> On Fri, 7 Apr 2000, Mark E Davidson wrote:
>
> > 2 steel rollers (one idler, one with encoder connection) $10.00 a set
> > 2 steel rollers with 4 new bearings
> > $25.00
>
> (I took out the FS because this is no longer a FS reply).
>
> What would constitute bearings on a roller, track ball, etc needing to be
> replaced ?
>
> One track ball I fixed had the bearings rusted solid, that was
> obvious. Likewise on the shafts -- the wear is quite visible. What should I
> look for to decide if the bearings should be replaced, or is it safe to
> assume that if the shafts are noticbly worn from the roller, just replace
> them ?
>
> -Chris
>
> ==========================================================
> Chris Candreva -- chris@westnet.com -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Apr 14 22:16:11 2000
This archive was generated by hypermail 2.1.8 : Thu Jul 31 2003 - 23:00:48 EDT