On Fri, 7 Apr 2000, Mark E Davidson wrote:
> 2 steel rollers (one idler, one with encoder connection) $10.00 a set
> 2 steel rollers with 4 new bearings
> $25.00
(I took out the FS because this is no longer a FS reply).
What would constitute bearings on a roller, track ball, etc needing to be
replaced ?
One track ball I fixed had the bearings rusted solid, that was
obvious. Likewise on the shafts -- the wear is quite visible. What should I
look for to decide if the bearings should be replaced, or is it safe to
assume that if the shafts are noticbly worn from the roller, just replace
them ?
-Chris
==========================================================
Chris Candreva -- chris@westnet.com -- (914) 967-7816
WestNet Internet Services of Westchester
http://www.westnet.com/
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Thu Apr 13 16:14:10 2000
This archive was generated by hypermail 2.1.8 : Thu Jul 31 2003 - 23:00:48 EDT