Red Baron AVG ROM question

Howdy,

I recently attempted to modify a Battlezone AVG board to run Red Baron
using the modification text listed in the ROM set used for MAME. The
modification is listed as follows:

All roms 2716 with the exception of H1, which is a 2732 with pin 18 pulled
up and a wire run to M2 pin 13

I performed this modification - and the game runs the self test but not the
game. In attempting to troubleshoot the boardset using the Red Baron
schematics, I noticed that H1 is listed as an 8316, with the same
address/data wiring as Battlezone.

???

Are the schematics incorrect, or is this modification not necessary?

I'd try it out, but ran out of 16K EPROMS..... : )

Thanks!

        - Matt

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon May 8 00:26:14 2000