If everything was hooked up correctly and R29 fried, you have a contact problem on the edge connector. This is a very common problem. I think half of my AR2's have had R29 blown :)
Jon
At 07:52 PM 10/16/2000, you wrote:
>Or at least differently.
>
>Bob Roberts just told me he didn't have any AR II 02's left, only 01s, 4s,
>and 6s. So I start looking at the differences.
>
>04 is missing the +12 and -5 voltages.
>
>Major Havoc uses an 04.
>
>I put the AR II from my Major Havoc in my SW, and it went poof.
>
>Looking at the wire lengths, I don't think I could have swapped J6 amd J9 --
>the wires aren't long enough. However, without +12 and -5 volts, I'll bet
>the board drew more current on the +5, enough to fry the AR II.
>
>And hopefully, not do much damage to the SW itself !
>
>
>Well, I can dream, can't I ?
>
>
>-Chris
>
>==========================================================
>Chris Candreva -- chris@westnet.com -- (914) 967-7816
>WestNet Internet Services of Westchester
>http://www.westnet.com/
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon Oct 16 22:42:10 2000
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:32:53 EDT