Re: Only 2k

Everthing is ok.. I can't see any arcing (lights out).. Resoldered the wires to
the focus assembley.. Recapped board.. Checked regs.. Replaced 3199 and mystery
can... Still the same thing... Must be time to order a Wintron, unless someone
has one for sale?

JB

Bret Pehrson wrote:

> How is the soldering? Clean and free of flux, traces ok? Have you tried
> running it in the dark to see if you can see any external arcing on board
> front or back? Check the wires coming out of the HVT -- sometimes these get
> pinched and the insulation gets cut/damaged. Pull the rubber boots off the
> leads going to the focus/screen assemble and check the connection.
>
> > -----Original Message-----
> > From: owner-vectorlist@synthcom.com
> > [mailto:owner-vectorlist@synthcom.com]On Behalf Of Joe Bachmann
> > Sent: Thursday, July 12, 2001 6:52 PM
> > To: vectorlist@synthcom.com
> > Subject: Re: VECTOR: Only 2k
> >
> >
> > Both 24's are good... I do have a wave form... Something is
> > making a noise kinda
> > like a plasma cutter type sound... A constant spark jump type sound..
> >
> > JB
> >
> > MKDUD@aol.com wrote:
> >
> > > In a message dated 7/11/2001 9:52:20 PM Eastern Daylight Time,
> > > joe.bachmann@newmail.net writes:
> > >
> > > << I am only getting 2kv to the tube from my HV board... Just
> > replaced the
> > > BU406D.. HVT rings out fine. >>
> > >
> > > What are you getting at the +/- 24 regs? How are you caps? Did
> > you reccap the
> > > board?
> > >
> > ------------------------------------------------------------------
> > ---------
> > > ** To UNSUBSCRIBE from vectorlist, send a message with
> > "UNSUBSCRIBE" in the
> > > ** message body to vectorlist-request@synthcom.com. Please direct other
> > > ** questions, comments, or problems to neil@synthcom.com.
> >
> > ------------------------------------------------------------------
> > ---------
> > ** To UNSUBSCRIBE from vectorlist, send a message with
> > "UNSUBSCRIBE" in the
> > ** message body to vectorlist-request@synthcom.com. Please direct other
> > ** questions, comments, or problems to neil@synthcom.com.
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Jul 13 23:57:57 2001