On Mon, 3 Sep 2001, Chris Starr wrote:
> 4) The Vector generator board is sending out the correct signals. I'm
> getting a great picture on my X-Y scope, and can actually play the game with
> the scope just fine. X and Y BIPs are set fine.
I assume you are testing this at the test point on the board ? What I would
do next is use the scope to start tracing the actual path to the monitor --
clip on to the wireing harness, possible the back of the card-edge
connector, then the connector to the monitor, then on the circuit of the
monitor itself . . .
==========================================================
Chris Candreva -- chris@westnet.com -- (914) 967-7816
WestNet Internet Services of Westchester
http://www.westnet.com/
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Sep 4 08:11:01 2001
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:41 EDT