Re: Another WG6100 problem child

Yes , x-out and y-out. Also been using the Z-out since the scope can support
it. Also I'm lucky enough to own a board that has the x and y centering
controls factory installed.

thanks for the input, didn't think it could be a wire problem, I was
guessing perhaps q604/q704. Knowing my luck lately, I probably did something
stupid like swap the positions of the chassis mount power transistors (i
just thought of that right now -- I better check it out before turning it
on!) I'm checking it out again this weekend since it isn't at my house right
now.

c-starr

----- Original Message -----
From: "Christopher X. Candreva" <chris@westnet.com>
To: <vectorlist@synthcom.com>
Sent: Tuesday, September 04, 2001 10:35 AM
Subject: Re: VECTOR: Another WG6100 problem child

> On Mon, 3 Sep 2001, Chris Starr wrote:
>
> > 4) The Vector generator board is sending out the correct signals. I'm
> > getting a great picture on my X-Y scope, and can actually play the game
with
> > the scope just fine. X and Y BIPs are set fine.
>
> I assume you are testing this at the test point on the board ? What I
would
> do next is use the scope to start tracing the actual path to the
monitor --
> clip on to the wireing harness, possible the back of the card-edge
> connector, then the connector to the monitor, then on the circuit of the
> monitor itself . . .
>
>
>
> ==========================================================
> Chris Candreva -- chris@westnet.com -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Sep 4 17:29:33 2001