All the zero ohm jumpers have been changed to wire already. I took care of
that.
These 1N914 diodes, they could cause the left have of the screen not to be
seen?
Dan Piraino
mccullar@flash.net wrote:
> I think you may have some small-signal diodes that are bad. This happens
> quite a bit on the SW deflection boards. 1N914 diodes are very cheap, so
> you may want to replace all of them to be sure.
>
> Also -- if your board has those brown zero-ohm jumpers, replace them all
> with bare wire. Those have a high failure rate, too.
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sun Sep 23 16:41:16 2001
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:42 EDT