I tested the 1n914 diode at CR11 and its bad. Thanks for the tip.
Dan Piraino
Daniel Piraino wrote:
> All the zero ohm jumpers have been changed to wire already. I took care of
> that.
> These 1N914 diodes, they could cause the left have of the screen not to be
> seen?
> Dan Piraino
>
> mccullar@flash.net wrote:
>
> > I think you may have some small-signal diodes that are bad. This happens
> > quite a bit on the SW deflection boards. 1N914 diodes are very cheap, so
> > you may want to replace all of them to be sure.
> >
> > Also -- if your board has those brown zero-ohm jumpers, replace them all
> > with bare wire. Those have a high failure rate, too.
> >
> > ---------------------------------------------------------------------------
> > ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> > ** message body to vectorlist-request@synthcom.com. Please direct other
> > ** questions, comments, or problems to neil@synthcom.com.
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sun Sep 23 16:57:41 2001
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:42 EDT