RE: Vector Virgin Has a question

> -----Original Message-----
> From: Jon Kotek [mailto:jkotek@madgenius.com]
> Subject: Re: VECTOR: Vector Virgin Has a question
>
> Common raster thinking, the screen adjustments are on the PCB not the
> monitor.
>
> Jon

Jon, why don't you cut the guy some slack, he prefaced his question by
saying
he was new. In fact you probably owe him an apology for that snide remark
you
made, unless you'd like to show *all of us* where the centering controls are
on a Star Castle CPU board.

Dean, in a nut shell:
 - Put SC in test mode
 - Make sure all of the lines connect where they're supposed to
 - Make sure everything is the correct size
 - Finally, use magnetic centering rings on yoke to center image

If you have any questions on doing this, *read* the manual.
If you don't have the manual, there's a Rip Off manual on spies,
which is close enough.

-Mark

P.S. There's also a small chance the overlay may have slipped.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sun Nov 11 14:38:49 2001