RE: A bad day in My arcade (V2000 help)

I guess I could have looked at the subject line instead of making a bunch of
assumptions.... And it's 14.5kv, not 19.5kv like I typed the first time.

> -----Original Message-----
> From: owner-vectorlist@synthcom.com
> [mailto:owner-vectorlist@synthcom.com]On Behalf Of Mills, Lewis
> Sent: Monday, July 15, 2002 12:35 PM
> To: 'vectorlist@synthcom.com'
> Subject: RE: VECTOR: A bad day in My arcade (V2000 help)
>
>
> Mark,
> I'm not sure what monitor Lunar Lander uses, so I'm assuming
> it's a 19". If
> the HV is only 12kv, I'd look there. I'm pretty sure the
> G05-802 and the
> 19V2000 are supposed to have 19.5kv. Unless LL uses an early
> G05 and it
> takes that much less HV....
> Lewis
>
>
> > -----Original Message-----
> > From: owner-vectorlist@synthcom.com
> > [mailto:owner-vectorlist@synthcom.com]On Behalf Of Christopher X.
> > Candreva
> > Sent: Monday, July 15, 2002 11:15 AM
> > To: vectorlist@synthcom.com
> > Subject: Re: VECTOR: A bad day in My arcade (V2000 help)
> >
> >
> > On Mon, 15 Jul 2002, Mark E Davidson wrote:
> >
> > > If I turn up the brightness, I do have a picture.. In
> fact, to looks
> > > just like my scope... Retrace lines and all. But there is
> > no way to to
> > > get a picture with out driving the brightness too high.
> > (and getting the
> > > center spot on the tube and all the lines.
> >
> > I'ld start with the Z circuit.
> >
> > Does your scope have a Z-input, so you could check that
> > comming from the
> > board too ? Otherwise I suppose you could just look at it as
> > a trace, just
> > to see if something is there.
> >
> > ==========================================================
> > Chris Candreva -- chris@westnet.com -- (914) 967-7816
> > WestNet Internet Services of Westchester
> > http://www.westnet.com/
> >
> > --------------------------------------------------------------
> > -------------
> > ** To UNSUBSCRIBE from vectorlist, send a message with
> > "UNSUBSCRIBE" in the
> > ** message body to vectorlist-request@synthcom.com. Please
> > direct other
> > ** questions, comments, or problems to
> vectorlist-owner@synthcom.com.
> >
> --------------------------------------------------------------
> -------------
> ** To UNSUBSCRIBE from vectorlist, send a message with
> "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please
> direct other
> ** questions, comments, or problems to vectorlist-owner@synthcom.com.
>
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Mon Jul 15 11:20:38 2002