Re: A bad day in My arcade (V2000 help)

The ORIGINAL monitor was a first generation G05 but was DOA. I replaced
it with a WG V2000 from a Battle zone and made an adapter to repin the
game to the connector on the monitor. Never had a monitor problem with
it till now. :-(

Mills, Lewis wrote:

> Mark,
> I'm not sure what monitor Lunar Lander uses, so I'm assuming it's a 19". If
> the HV is only 12kv, I'd look there. I'm pretty sure the G05-802 and the
> 19V2000 are supposed to have 19.5kv. Unless LL uses an early G05 and it
> takes that much less HV....
> Lewis
>
>
>
>>-----Original Message-----
>>From: owner-vectorlist@synthcom.com
>>[mailto:owner-vectorlist@synthcom.com]On Behalf Of Christopher X.
>>Candreva
>>Sent: Monday, July 15, 2002 11:15 AM
>>To: vectorlist@synthcom.com
>>Subject: Re: VECTOR: A bad day in My arcade (V2000 help)
>>
>>
>>On Mon, 15 Jul 2002, Mark E Davidson wrote:
>>
>>
>>>If I turn up the brightness, I do have a picture.. In fact, to looks
>>>just like my scope... Retrace lines and all. But there is
>>>
>>no way to to
>>
>>>get a picture with out driving the brightness too high.
>>>
>>(and getting the
>>
>>>center spot on the tube and all the lines.
>>>
>>I'ld start with the Z circuit.
>>
>>Does your scope have a Z-input, so you could check that
>>comming from the
>>board too ? Otherwise I suppose you could just look at it as
>>a trace, just
>>to see if something is there.
>>
>>==========================================================
>>Chris Candreva -- chris@westnet.com -- (914) 967-7816
>>WestNet Internet Services of Westchester
>>http://www.westnet.com/
>>
>>--------------------------------------------------------------
>>-------------
>>** To UNSUBSCRIBE from vectorlist, send a message with
>>"UNSUBSCRIBE" in the
>>** message body to vectorlist-request@synthcom.com. Please
>>direct other
>>** questions, comments, or problems to vectorlist-owner@synthcom.com.
>>
>>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to vectorlist-owner@synthcom.com.
>
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Mon Jul 15 11:36:10 2002