Re: Need help with Star Trek spinner PCB

-----Original Message-----
From: "Matt Rossiter" <rossiter@ni.net>
To: <vectorlist@synthcom.com>
Date: Thu, 3 Oct 2002 17:34:47 -0700
Subject: VECTOR: Need help with Star Trek spinner PCB

>
> I've almost got my Sega Multigame all working. The buttons all work, but
> the spinner still does not seem to work. I'm thinking the opto-electric
> encoder might be bad. Does anyone know where I might be able to find a
> replacement part? I've verified that the +5v is good and no broken wires.
> This would be for a Star Trek control panel.
>
> Matt
>
i remember a thread about these before,

check the ground wire, and then scope the +5v for regulation and check the outputs.

i recall the problem was at the other end of the loom in some way.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Thu Oct 3 20:00:57 2002