That should fix it, thanks Rodger!
John :-#)#
At 12:55 AM 07/11/2002 -0600, Rodger Boots wrote:
>Gregg Woodcock wrote:
>
>>The first raster hack I did was NO PROBLEMO! But these last 2 have the
>>unusual problem that the brightness is WAY, WAY too high. It is not the
>>case of a bad brightness pot because I can see a definite change when it is
>>used. It is just that the range is way too high. I tried adding in almost
>>1MOhm in series with the G2 connection to the picture tube and it was still
>>dazzlingly bright. Is there a good way to drop the G2 somewhere before it
>>gets ramped up (i.e. low voltage and low resistor)? John, is there
>>something I may have forgotten that I did the first time that I'm not doing
>>on these last 2?
>>
>>
>Instead of putting the 1 megohm in series with the G2 line try connecting
>it from the G2 line to ground.
>
>
>--
>Interested in a possible way to financial freedom? Please
>check out www.quickinfo247.com/7622016/FREE
>
>
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to vectorlist-owner@synthcom.com.
>
>
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Thu Nov 7 12:20:33 2002
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:34:14 EDT