I usually use the strips.. just cut them to length.
They don't always line up exactly vertical, but they're easier for this shaky
guy to solder in and you can see the traces where they run under the chip. If
the board is thin, I use a socket though, better support.
> I use BG Micro, $1.35 for 3 of any size up to 40 pin. You dont always get
> the same socket but they all work well
>
> Art
>
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Fri May 9 11:35:57 2003
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:34:29 EDT