RE: WG6100 monitor woes

Either use a very small screw driver to push back the tab that holds it
on. Or, use the tool that Bob sells. I happen to sell the tools for the
Molex and Amp connectors.

JB

-----Original Message-----
From: owner-vectorlist@vectorlist.org
[mailto:owner-vectorlist@vectorlist.org] On Behalf Of Phil Morris
Sent: Thursday, December 04, 2003 12:28 PM
To: vectorlist@vectorlist.org
Subject: Re: VECTOR: WG6100 monitor woes

>Just to be clear -- it ended up being not the pin on the monitor board,
but
>the 'finger' inside the plastic connector housing that was dirty. SO, I
>pulled each one from the connector houseing and clean those.

Noted. Just out of interest, what is your preferred method for removing
the
pins from a molex housing?

Phil

------------------------------------------------------------------------

---
** Unsubscribe, subscribe, or view the archives at
http://www.vectorlist.org
** Please direct other questions, comments, or problems to
chris@westnet.com
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com