>I measured at the board and found -21 volts at the X test point and found
13 volts at the Y. What would cause this? Can I assume the board is jacked
and send it for repair?
Are you sure that you are using ground for your reference point? You
shouldn't get anything lower than -15V, even if there were a DAC problem.
You might have a blown -15V regulator (7915) which is passing the full
-22VDC thru it.
Alex
---- ayeckley@elektronforge.com www.elektronforge.com --------------------------------------------------------------------------- ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org ** Please direct other questions, comments, or problems to chris@westnet.comReceived on Mon Sep 26 11:10:31 2005
This archive was generated by hypermail 2.1.8 : Mon Sep 26 2005 - 11:50:02 EDT